Search By Part Number	Straight Accessories 90° Accessories 45° Accessories Miscellaneous Accessories Support Data/ Assembly Procedures   Descriptions Plating Index, Torque Values Crimp Ring Data Chart Military to Commercial Part Number Reference Chart. Spin Coupling Data AP2 AP3 AP6 AP7 AP9 AP10 AP16 AP27 AP28 AP95 AP463 AP28840 CLICK HERE TO VIEW A LARGER IMAGE
SUGGESTED ASSEMBLY PROCEDURE Temporarily assembly item 1* to conector. Place remaining adapter components on cable in sequence shown. Keep these componenets away from termination so they will not interfere with subsequent assembly steps. Insert cable into item 1* and bottom on connector. Mark cable at rear of item 1*. Disassemble item 1* from connector and slide up cable with the other components. Trim jacket (if applicable) approx. 1/2 inch in back of mark, be sure cable jacket will be under gland for proper seal) for individual shielding, prepare in accordance with Sunbank assembly procedure AP95. Fold back up cable & tie. For overall shield, comb out & fold back up cable & spot tie or tape. Prepare & terminate conductors in normal practice. Assemble item 1* to connector, & tighten securely. Untie shielding & arrange evenly about cone at rear of item 1*. SLide ground ring into place over shield. Fold shield back over ground ring spot tie. Trim excess shield. Engage cable clamp or rear adapter to item 1*, tighten securely. Tighten clamp saddle bars around cable. * Item 1, 90° assembly includes adapter (item 1a) and elbow (item 1b) sub-assembled.